The Timken Company
The Timken Company
4500 Mt Pleasant St. NW
N. Canton, OH 44720
Phone: (234) 262-3000
E-Mail: CustomerCAD@timken.com • Web site: www.timken.com
Print Back
Like the TS bearing design, the TSF design consists of two main separable parts: the cone (inner ring) assembly and the cup (outer ring). It is typically mounted in opposing pairs on a shaft. TSF bearings have flanged cups to facilitate axial location and accurately align seals in through-bored housings.
Unit of Measure

Specifications

Series

 N/A L730600

Cup Part Number

 N/A JL730612-B

Design Units

 N/A METRIC

Full Timken Part Number

 N/A L730600

Dimensions

D - Cup Outer Diameter

 N/A 205 mm8.0709 in

D1 - Flange Outer Diameter

 N/A 210.000 mm8.2677 in

C - Cup Width

 N/A 21.438 mm0.8440 in

C1 - Cup Flange Width

 N/A 4.862 mm0.1914 in

Abutment and Fillet Dimensions

r - Cup Backface "To Clear" Radius1 N/A 3.30 mm0.130 in

Da - Cup Frontface Backing Diameter

 N/A 200.91 mm7.91 in

Factors

K - Factor2 N/A 1.27
e - ISO Factor3 N/A 0.46
Y - ISO Factor4 N/A 1.31

G1 - Heat Generation Factor (Roller-Raceway)

 N/A 295

G2 - Heat Generation Factor (Rib-Roller End)

 N/A 103
Cg - Geometry Factor5 N/A 0.176
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 3 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 4 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 5 Geometry constant for Lubrication Life Adjustment Factor a3l.