CAD (0) ▾
  • Cart is empty
  1. Request CAD files
Tapered Roller Bearings - 2S (Matched Bearing Assembly, with snap ring spacer)
Request Information
Unit of Measure

Specifications

Cone Part Number

 N/A 392

Cup Part Number

 N/A 394A

Inner Spacer Part Number

 N/A K444667R

Outer Spacer Part Number

 N/A K444668R

Design Unit

 N/A Inch

Dimensions

d - Bore

 N/A 2 7/16 in61.913 mm

D - Cup Outer Diameter

 N/A 4.3307 in110 mm

T - Width

 N/A 1.9502 in49.535 mm

C - Width

 N/A 1.7002 in43.185 mm

Snap Ring Diameter

 N/A 4.57 in116.10 mm

Snap Ring Width

 N/A 0.22 in5.54 mm

Abutment and Fillet Dimensions

R - Cone Backface "To Clear" Radius1 N/A 0.03 in0.800 mm
r - Cup Backface "To Clear" Radius2 N/A 0.050 in1.27 mm

db - Cone Backface Backing Diameter

 N/A 2.76 in70 mm

Da - Cup Frontface Backing Diameter

 N/A 4.15 in105.40 mm

Basic Load Ratings

C90 - Dynamic Radial Rating (90 million revolutions)

 N/A 5760 lbf25600 N
C1 - Dynamic Radial Rating (1 million revolutions)3 N/A 38700 lbf172000 N
Ca90 - Dynamic Thrust Rating (90 million revolutions)4 N/A 3970 lbf17600 N
C90(2) - Dynamic Radial Rating (Two-Row, 90 million revolutions)5 N/A 10000 lbf44600 N

Factors

K - Factor6 N/A 1.45
e - ISO Factor7 N/A 0.4
Y1 - ISO Factor8 N/A 1.68
Y2 - ISO Factor9 N/A 2.5
  • 1 These maximum fillet radii will be cleared by the bearing corners.
  • 2 These maximum fillet radii will be cleared by the bearing corners.
  • 3 Based on 1 x 106 revolutions L10 life, for the ISO life calculation method.
  • 4 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 5 Based on 90 x 106 revolutions L10 life, for The Timken Company life calculation method. C90 and Ca90 are radial and thrust values for a single-row, C90(2) is the two-row radial value.
  • 6 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 7 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 8 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.
  • 9 These factors apply for both inch and metric calculations. Consult your Timken representative for instruction on use.